Significant Doors CS 6 AppVar Sections
- Start+0 PrognameSpace: used to store the top element in the Archive stack, essentially the name of the program being run. [9 bytes]
- Start+9 PrognameSpace2: used to store the second element in the Archive stack, the name of the first program run if it called a second program. [9 bytes]
- Start+18 SafeArcFlags: Used to remember the page that the primary program is on [2 bytes]
- Start+19 SafeArcFlags+1: Page of data file if an AP. [n/a bytes]
- Start+20 SafeArcFlags3: Used to remember the page that the secondary program is on [1 byte]
- Start+23 ProgNameSpace3: Used for Associated Programs [9 bytes]
- Start+56 ProgNameSpace4 - Used for Associated Programs [9 bytes]
- Start+65 ????
Significant Code Sections
- The bulk of the changes to make. All kinds of messes, to be detailed in the section below.
- Clears out the first nineteen bytes, then copies 9 bytes from +0 to +24, then copies 9 bytes from +0 to +56 (FAIL?)
- Gets page from +18.
- Uses GetArcStatus to determine if program is archived
- If unarchived, skips to execution of the original, with name stored in +0
- If archived, stores page in +18, creates temporary program, and executes that.
- Returns ProgNameSpace at +0 if GetArcStatus returns 0, or ProgNameSpace2 at +9 if it returns !=0.
- Returns ProgNameSpace3 at +23 if +19 is 0, or ProgNameSpace4 at +56 if +19 is !=0.
- (Un)archives program at +0 if +18 is nonzero
- Uses +18 and then either +0 or TmpProgName to find subprograms to unarchive (or rearchive)
- Uses ArcUnarcProgA (looking at VFAT) to store the program archive status and name at +18 and +0 respectively
- Copies file name from +0 to +23
- Calls initTmpASM if file is archived
- Moves the archive status of the file from +18 to +19
- Copies from +9 to +56 (9 bytes to copy), then zeroes out first +18 bytes
- Calls GetRAMNameAP
- Get type of current file, search for a viewer
- On success, run ArcUnarcProgA_Op1 to store viewer program arc/name in +18 and +0
- RunTIOSASM, RunDCSasmProg, RunDCSasmProgAP:
- Uses +18 and +0
- On execution completion, uses GetRAMName for writeback if necessary
- Uses +19 for ???
- This is the routine that stores a temporary name into +9, of the same length as the original program's name
- Nothing in this file specifically, but will need to deal with all prgms called from BASIC prgms
- In FOpen, have to deal with writing back an existing open AP file, then closing it (shouldn't be too bad)
- FOpen seems to clear out +19, +20, then +23 to +30, then +56 to +63.
- FileSave / FileSaveAs don't do anything auspicious
- APOpenGuiCopyToRAM: Uses offset +19, +23, and +56.
- TmpProgName and TmpProgName2?
- Seems to use ProgNameSpace 3 and 4.
- Therefore ProgNameSpace 3 and 4 would seem to involve files, making ProgNameSpace 1 and 2 for programs?
Summary of Existing ProgNameSpaces
- For a normal ASM program, +0 contains original name, +9 maybe contain a temporary name, and +18 marks whether +0 or +9 is the name of the program in RAM
- For an AP file, +23 and +56 have the original [and temporary] name of the file, while +0 and +9 have the viewer. +19 marks whether +23 or +56 is the RAM name of the AP file. Not sure what SafeArcFlag3 (+20) is for, though.
- As far as I can tell, SafeArcFlags3 isn't actually used for anything anymore.
New Chaining System
S: Size in number of entries in the AppVar. AppVar size is 1+20*S. (1 byte)
A1: Flag for program (0) or associated file (1). (1 byte)
B1: 05/06 (ProgObj/ProtProgObj). (1 byte)
C1: program name (8-byte space, zero-padded). This is the original name if A2 is non-zero, or the original and RAM name if A2 is zero. (8 bytes)
A2: Flag for RAM or archive, indicates page of original. Zero for RAM, nonzero for ROM. (1 byte)
B2: 05/06 (ProgObj/ProtProgObj). (1 byte)
C2: program name (8-byte space, zero-padded). This is the temporary RAM name if A2 is non-zero, or not used if A2 is zero. (8 bytes)
The AppVar will contain repeating instances of these two rows as it grows.
PushProgChain: Pushes a new blank 20-byte slot consisting of A1 through C2 above onto the end of the CHAIN7 AppVar, and expands it accordingly with InsertMem. Increments S. If the AppVar did not already exist, creates it with size 21 bytes (S and first 20-byte slot). Returns with HL pointing to the A1 byte of the new entry; if the carry flag is set, something bad happened, and HL is probably invalid. [COMPLETE, TESTED]
PopProgChain: Removes the 20-byte slot in the highest memory in CHAIN7. If this would remove the last slot, removes the entire CHAIN7 AppVar from memory. There is no usable return value from this function. [COMPLETE, TESTED]
GetProgChainSize: Returns the value of S in A. If the CHAIN7 AppVar does not exist, returns A=0. [COMPLETE, TESTED]
GetProgChainTop: Returns HL as the lowest byte of the topmost entry. In other words, returns HL = (begin)+1+20*(S-1). Returns the carry flag set if the CHAIN7 AppVar does not exist, or if (somehow) S=0. Pushes and pops Op1 around the whole thing, so Op1 is retained, at the cost of trashing lots of registers.[COMPLETE, TESTED]
- Completed four functions above in 143 bytes. Untested. (5/16/2010)
- Upgraded BASIC sections, tested, debugged. (5/16/2010)
- Upgraded ASM sections, writeback, AP sections, performed testing, found more items to upgrade. (5/16/2010)
- Debugging ASM functionality, began work on AP GUIs. (5/17/2010)
- Wrote and debugged routine to move gui7 appvar to highmem. Removed Power menu to save 280 bytes. (5/18/2010)
- Worked on FileOpen/Save/SaveAs, introduced RelocatablePtr1 and 2. (5/19/2010)
- Continued debugging FileOpen/Save/SaveAs, also solve an unrelated graphics bug. (5/20/2010)
Significant Code Upgrades
- RunProgImmediate: [INCOMPLETE]
- RunBASICProg: [COMPLETE, TESTED]
- GetRAMName: [COMPLETE, TESTED]
- GetRAMNameAP: [COMPLETE, TESTED]
- ArcUnarcProgB: [DELETED, UNNECESSARY]
- ArcUnarcDCSBasic: [COMPLETE, TESTED]
- RunAssociatedProg: [COMPLETE, TESTED]
- RunTIOSASM: [COMPLETE, TESTED]
- RunDCSasmProg: [COMPLETE, TESTED]
- RunDCSasmProgAP: [COMPLETE, TESTED]
- ASMContinueAll: [COMPLETE, TESTED]
- Hook1: [COMPLETE, TESTED]
- InitTmpASM: [COMPLETE, TESTED]
- asmcheckwriteback: [COMPLETE, TESTED]
- asmcheckwriteback2: [DELETED, UNNECESSARY]
- FOpen: [COMPLETE, TESTED BUGGY]
- FileSave: [COMPLETE, TESTED BUGGY]
- FileSaveAs: [COMPLETE, TESTED BUGGY]
- APOpenGuiCopyToRAM: [DELETED, UNNECESSARY]